What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 11:04

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
A circuit breaker is similar, but is resettable.
What is your review of UST Global?
He then describes the function of a fuse.
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Which city should one visit between Nice and Cannes? Why?
Edit 2024–10.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It seems Mohan does not understand the difference between a comment and an Answer.
The other is “what does a “fuse” do?”
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes Rainy Season and Lightning.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
In schematic diagrams this is the symbol for a fuse:
S.A.-area rabies cases spark concern for officials. Here's why - MySA
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
[old diagram got deleted by accident]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Upvotes:
2024–10–10[John johnson John Johnson ]
so, what happens?
How could Trump, with his deplorable garbage supporters, manage to win an election?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The bolt then partially travels down the line to your home.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The Law Firms That Appeased Trump—and Angered Their Clients - WSJ
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
One
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
For this case there are devices called Metal oxide varistors (MOV).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At one ohm, the resistor has a maximum of 1 watt power.
What are some common lies that addicts may tell themselves?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
At least they know the answer if they wanted it.
WWDC 2025: New Features We Could See in watchOS 26 - MacRumors
What is lightning?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
If sea levels were rising, wouldn't the acreage of coastal salt marshes increase? Are they?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So, the voltage could go up to 500 volts, and the fuse will not open up.
These are simplified answers to the original question, and does not change anything I wrote above.
Why Cutting Carbs Usually Backfires—and What to Do Instead - EatingWell
I post the exact comment here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
nine
(Dc diagram shown, AC is similar).
But… the neutral is now “floating” because of the 1 ohm resistance.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
What does a fuse do?
The third is lightning and “how it gets conducted into a home.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Here is a simplified AC power diagram.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
the problem then depends on "how fast does the fuse operate?".
He then asserts :
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
There are two important concepts here.
what exactly is a ‘surge’ protector?
This is where the MOV conducts again, and dissipated the energy.
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
An AC voltage/ current source, and an ac inductive load.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A fuse is a non-resetable over current circuit protector.
a photo is worth a thousand words.
but I think this circuit , shows a few more pieces.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
[image of Common-mode choke]
This device then solves the entire problem.
First Sentence:
eight
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–16 [ OO OLAOYE OYEBODE ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This one hit behind the barn.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are three different concepts here that are getting confused.
One is “what exactly is in a ‘surge protector’ ? ”
This is 'the assistant's answer'
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–14 [Omar Gharbi Omar Gharbi ]